Modular Plate First: Place the fixed platen flat on the worktable and check its flatness.
Install the locating pins, guide sleeves, and cooling plate. Perform a sealing test using low-pressure air or hydraulic pressure.
Core Component Placement: Install the core component into the fixed platen and adjust the locating pins to ensure it is properly seated.
Pre-install the ejector mechanism, check the ejector pin stroke, and apply a thin layer of grease to the ejector pin seats to ensure smooth sliding.
Moving Plate Alignment: Close the fixed platen and the moving platen (Movable Plate) together, aligning them using the guide pins on both sides.
Gradually and gently close the mold, using a feeler gauge to check the parting line clearance for uniformity (recommended within 5–10 μm). Ensure there is no misalignment or excessive height after closure.
Slider and Ejector Mounting: Install the slider assembly on the moving mold side. First, install the guide ejector mechanism, then tighten the ejector belt or connecting rod.
After mold closing, manually push the ejector rod to confirm that the slider moves smoothly without collision or interference.